Laboratory Technology

The gloss meter PCE-IGM 60 is an optical measuring instrument with a measuring geometry of 60°. The surface is analyzed by the gloss meter and then the result is shown. Every surface has the characteristic to reflect light.

• Measurement geometry: 60° degree angle
• Measuring range: 0 … 300 GU
• Standards: ISO 2813 / GB/T 9754 / ASTM D 523 / ASTM D 2457
• Light source: D65
• Wave length: 400-700 nm

The PCE-SGM 60 gloss meter with small measuring area is used on many types of surfaces to quantify their gloss units. This gloss-measuring device operates on the reflection principle by sending light from a calibrated light source onto the surface to be tested and then calculates the gloss level of the surface according to the reflection of light particles. This gloss meter allows you to measure very high gloss surfaces above 70 gloss units (GU).

• Measurement geometry: 60° degree angle
• Measurement up to 1000 gloss units
• Internal reading memory up to 5000 readings
• 3.5" TFT display
• Light source: D65
• Wave length: 400-700 nm

The Roughness Tester PCE-RT 10 is a small, light device with simple navigation. Despite the fact that the device functions on a very complex and elaborate level, the measurement results can be acquired quickly and in an accurate way. Very simple to operate with a motorized diamond sensor.

• Measures Ra in Metric (µm) and Imperial (µinch)
• Ra 0.05 to 10um / 2 µinch … 400 µinch measurement range
• Rz 0.1 to 50um / 3.93 µinch … 1968.50 µinch measurement range
• Induction method with Diamond sensor
• Accuracy < ± 10% and Repeatability < 6%
• With threshold function
• Uses 4 AA Batteries (Included)

• simulation of different illuminants
• hour counter for each illuminant
• short warm-up time
• LED lighting
• meets ASTM D1729, ISO3664, DIN, ANSI, BSI

The color matching cabinet is a simulation instrument, which is mainly used in quality control. The color matching cabinet accurately  corrects light types and thus enables the direct comparison of products which must have special color characteristics.

• Simulation of different light types
• Hour counter for each light type
• Short warm-up time
• LED light
• According to ASTM  D1729, ISO3664, DIN, ANSI, BSI

The PCE-CIC 11-US Color Matching is a simulation instrument, which is mainly used in quality control. The Color Matching accurately  corrects light types and thus enables the direct comparison of products which must have special color characteristics.

• Simulation of different light types
• Hour counter for each light type
• Short warm-up time
• According to ASTM D1729, ISO3664, DIN, ANSI, BSI

The simple design and an absolutely straightforward operation make it possible for the practitioner to use the adhesion tester as an instrument for daily adhesion tests. Using adhesive with rapid curing, the tests can be performed by the user in the shortest possible time.

• Breakout force: 200 kg
• Diameter of base dolly, mm: 15.1 (№ 1) and 19.5 (№ 2)
• Specific breakout force, MPa: Dolly №1 up to 10 MPa (100) Dolly  №2 up to 6 MPa (60)