In addition to testing concrete, the NDT Tester can also store measured data. The stored measurement data can be transferred from the NDT Tester to a PC after a measurement run. For this, the mini-USB interface is available on the NDT Tester. The evaluation of the measurements from the NDT Tester is carried out with the supplied PC software.
The NDT Tester displays measurements Rebound Value and can display force in PSI, MPa, kgF/cm², or N/mm². The NDT Tester can be setup to measure at test angles of downward(-90°), downward(-45°), horizontal (0°), upward(45°), or upward(90°).
|Measuring range||10 ... 60 N/mm² / 1500 ... 8500 PSI or lbs/in²|
|Accuracy||± 0.1 R|
|Nominal kinetic energy||2.207 Nm, 0.225 kgm|
|Interface||Bluetooth, micro USB|
|Storage||1,000 data units with 256 measurements each|
|Operating conditions||-40 ... 60°C / -40 ... 140°F|
|Power supply||3.7V Li-ion battery|
|Power supply (power supply)||Primary: 100 ... 240V AC, 50/60 Hz|
|Secondary: 5V DC, 1 A|
|Dimensions||280 x 75 x 60 mm / 11 x 3 x 2.4 in|
|Weight||About 1.2 kg / 2.6 lbs|