Order no.: PCE-PVS 10

Acceleration Sensor PCE-PVS 10

Question / Callback

Delivery time: 1-2 working days

Description

Acceleration Sensor for monitoring the vibration speed / 4 ... 20 mA output

MIL-C-5015 connection / 3 ... 1500 Hz bandwidth

The Acceleration Sensor has been developed for the continuous monitoring of the vibration speed. The Acceleration Sensor is available in different versions. Depending on the type of vibration sensor, a distinction is made between design and measuring range. The Acceleration Sensor measures the vibration speed in the range of ± 12.7 mm / s or ± 25.4 mm / s in the frequency range between 3 Hz and 1500 kHz.

The measured vibration speed is output as a 4 ... 20 mA process current. The Acceleration Sensor is looped through a MIL-C-5015 connector to a controller or process display. Depending on the design, the connection socket is attached to the vibration sensor vertically or horizontally. The Acceleration Sensor can be operated with a voltage of 12 ... 24 V DC.

Highlights

- horizontal or vertical installation

- Process signal output

- MIL-C-5015 connector

- M6 process connection

- different measuring ranges

- robust construction

Specification

Measuring range	± 12.7 mm / s
frequency range	3 ... 1500 Hz
output	2 conductors 4 ... 20 mA
sensitivity	<5%
Shock limit	± 1000 g
Power supply	12 ... 24 V DC in current loop
Isolation from ground	> 108 ohms
Output impedance	<100 ohms
design	Vertical connection
Electrical connections	Pin A: + 4 ... 20 mA
	Pin B: - 4 ... 20 mA
Connection type	2 pin MIL-C-5015
operating temperatur	-40 ... 85 ° C
Dimensions	Ø22 x51
Mounting thread	M6

Delivery Scope

1 x Acceleration Sensor PCE-PVS 10

1 x MIL-C 5015 plug to 5 m cable

1 x instruction manual

Downloads

Datasheet

Accessories

Panel Indicator

Panel Indicator PCE-DPD-U

£ 154.00

Price excl. VAT &. delivery
2 year Warranty

The installation display can be configured as AC and DC voltmeters (up to 600 Vac / DC), AC and DC ammeters (up to 5 AAC / DC). Furthermore, the built-in display shows measured values of process signals (mA, VDC), thermocouples, resistive temperature sensors (Pt, Ni, PTC and NTC), resistors, potentiometers and frequency.

Input:
2-, 3- wire
Thermocouples
Potentiometer
Resistance
Process signals
Frequency
DC voltage
DC power
AC voltage
AC power

Digital Universal Indicator

Digital Universal Indicator PCE-N30U

£ 168.00

Price excl. VAT &. delivery
2 year Warranty

The digital universal indicator can process several different input signals, such as 0…410/4010 Ohm, -10…+63 mV DC, -13…+13 V DC, -24…+24 mA DC or signals from thermocouples and resistance thermometers. This makes the digital universal indicator applicable in a wide range of applications. The measured values are shown on the large LED display of the digital universal indicator.

21-point scaling
IP 65 protection on the front
Three-colored display
Two alarm outputs