PCE-COM 20 is a portable handheld non-destructive material tester for non-ferrous metals. This non-destructive testing (NDT) device uses eddy current to determine the electrical conductivity of non-ferrous metals such as aluminum and copper. Includes 3 standards for testing.
- Operating frequency: 60 kHz
- Sine wave probe: Ø 14 mm / ≈ 0.55 in
- Memory: Up to 500 groups of measurements
- Lift-off and temperature compensation
- Automatic calibration
The environmental tester with microprocessor is a high precision 1-channel temperature gauge. The environmental tester with microprocessor is ideal for use with various Pt100 sensors. Due to the fact that it uses 4-wire technology, it has a very fast response time and precision.
- 1 channel temperature recorder
- Automatic shutdown
- High accuracy of ± 2 % r.H.
- Sampling rate of 2 / sec
- Memory size: 5,000 values
PCE-5000 is a portable hardness tester that uses the ASTM A1038 ultrasonic contact impedance (UCI) method to measure the hardness of metals and alloys with a minimum thickness of 2 mm / .08 in Non-destructive testing produces microscopic indentation.
- Measurement according to ASTM A1038 ultrasonic contact impedance (UCI) method
- Measurement units: Rockwell A (HRA), Rockwell B (HRB), Rockwell C (HRC), Brinell (HB), Vickers (HV) and MPa (N/mm²) SI units
- Measurement ranges: 61-85.6 HRA, 41-100 HRB, 20.3-68 HRC, 85-650 HB, 50-999 HV, 255-2180 MPa (N/mm²)
- Accuracy: ± 1.5 HR, ± 3% HB, ± 3% HV, Repeatability: ± 0.3%
- Memory size: 1,000 groups for measurement data and 20 groups for calibration data
- Different probe types (also automatic motorized probes) available
The Environmental Tester measures α-, β-, γ- and X-rays and offers a high measurement accuracy and convenient design. Using the integrated Bluetooth interface in the Environmental Tester, the measured values can be sent in real time to a PC and analyzed with the included software.
- Α-, β-, γ- and X-rays
- Bluetooth interface
- Internal memory
- Software Included
PCE-COM 20 is a portable handheld non-destructive conductivity tester for non-ferrous metals. This non-destructive testing (NDT) device uses eddy current to determine the electrical conductivity of non-ferrous metals such as aluminum and copper. Includes 3 standards for testing.
- Operating frequency: 60 kHz
- Sine wave probe: Ø 14 mm / ≈ 0.55 in
- Memory: Up to 500 groups of measurements
- Lift-off and temperature compensation
- Automatic calibration
The environmental tester is a portable and effective measuring device with multiple capabilities for inspecting water quality. Offering extraordinary precision at an affordable price, the environmental tester is used for laboratory and in situ testing of the pH value, redox, conductivity, salt content, oxygen level and temperature of water.
- Parameter: pH, Redox, Conductivity, TDS, Salt, Oxygen, Temperature
- Automatic temperature compensation
- Sampling rate of 1 sec.
- SD card memory (16 GB max.)
- Interface: RS-232
- 3 point calibration
- Electrodes for pH and conductivity included
Profilometer PCE-RT 11 is a portable measuring instrument for determination of surface roughness according to Ra, Rz, Rq and Rt in just one device.