The PCE-CL 20 is a cable locator used to detect live and voltage-free electrical wires. This cable detector also can be used to locate metallic and non-metallic gas or water pipes, identify short circuits, and follow lines inside walls or under flooring.
- Output signal: 125 kHz
- Compatible with one- or two-pole circuits
- Automatic, manual and UAC measuring modes
PCE-180 CBN is a handheld, portable, battery-powered wire tracer or cable locator that consists of an amplifier probe and acoustic signal or tone generator. This locating device is designed to detect wires or cables hidden behind walls or insulation.
- Uses an acoustic signal to detect wires and cables, including
network and coaxial cables
- Features a 3-position toggle switch (and 3-color LED) for line
polarity, continuity and voltage testing
- Comes with red and black test leads with alligator clips
PCE-EM 30 is a digital portable 3-axis electromagnetic radiation detector or EMF detector used to measure electromagnetic radiation generated by electronic devices and electric installations. This triple-axis EMF meter provides greater precision than single-axis models as well as affords the ability to assess EMFs from more than one source at a time.
- Measuring range: 0 to 199.99 V/m, 0 to 99.999 W/m², 0 to 9.9999 mW/cm²
- EMF bandwidth: 100 kHz to 3 GHz
- Measures EMF of 5G cellular Low-band and Mid-band
- Comes with two external sensor probes (for low and high frequency ranges)
PCE-COM 20 is a portable handheld non-destructive conductivity tester for non-ferrous metals. This non-destructive testing (NDT) device uses eddy current to determine the electrical conductivity of non-ferrous metals such as aluminum and copper. Includes 3 standards for testing.
- Operating frequency: 60 kHz
- Sine wave probe: Ø 14 mm / ≈ 0.55 in
- Memory: Up to 500 groups of measurements
- Lift-off and temperature compensation
- Automatic calibration
The PCE-CL 20 is a cable fault meter or locator used to detect live and voltage-free electrical wires. This cable fault meter also can be used to locate metallic and non-metallic gas or water pipes, identify short circuits, and follow lines inside walls or under flooring.
- Output signal: 125 kHz
- Compatible with one- or two-pole circuits
- Automatic, manual and UAC measuring modes
PCE-COM 20 is a portable handheld non-destructive material tester for non-ferrous metals. This non-destructive testing (NDT) device uses eddy current to determine the electrical conductivity of non-ferrous metals such as aluminum and copper. Includes 3 standards for testing.
- Operating frequency: 60 kHz
- Sine wave probe: Ø 14 mm / ≈ 0.55 in
- Memory: Up to 500 groups of measurements
- Lift-off and temperature compensation
- Automatic calibration
LTS-20 Force Gauge Test Stand is designed to be used in combination with either the PCE-FM series, PCE-DFG series, or PCE-PTR. The Test Stand offers the ideal solution for measuring traction and compression, and guarantees precise correspondence between the test matrix and the test position.
- Maximum usable length: 345 mm
- Total length: 530 mm (without hand wheel)
- Hand wheel diameter: 120 mm
- Maximum range of force: 1000 N / 100 kg / 220 lbs
- the mounting plate ADP-UNI must be ordered at the same time!