HVAC Meter / HVACR Tester

Order no.: PCE-EM 888

PCE-EM 888 is a portable handheld HVAC meter ideal for monitoring environmental conditions and the performance of heating, ventilation and air conditioning (HVAC) systems. This multifunctional digital device is used to measure wind speed, volumetric air flow, temperature, relative humidity, light and barometric pressure.


- Wind speed
- Volumetric air flow
- Air temperature
- Relative humidity
- Type K thermocouple sensor
- Barometric pressure
- Light

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-DC1-ICA
This HVAC meter was developed for the indirect acquisition of AC / DC currents as well as the frequency. A non-contact voltage tester function and a flashlight for illuminating the measuring point were also integrated in this HVAC meter. 

- AC / DC current, AC voltage and frequency measurement
- Integrated measuring point illumination
- Non-contact voltage tester
- Automatic range selection
- Forceps opening: 18 mm
- Automatic switch-off
- Incl. ISO calibration certificate
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-LD 1

PCE-LD 1 is a portable handheld gas detector used to locate CFC/HFC refrigerant gas leaks. This highly sensitive gas leak detector can locate gas leaks from HVACR refrigeration systems even in areas contaminated by other gases. The gas sensor is located at the end of a 390 mm / 15.35 in flexible goose-neck tube, allowing unique access to hard-to-reach places.


- Adjustable high/low sensitivity:
    6 g/yr or 30 g/yr for R-22 and R-134a
    8 g/yr or 40 g/yr for R404A, R-407C and R-410A

 

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-CM 3-ICA
The PCE-CM 3 HVAC meter is used for quick and easy AC measurements. For current measurement, the PCE-CM 3 HVAC meter is plugged over the live conductor. The HVAC meter PCE-CM 3 is particularly suitable for the measurement of alternating current in distributions and wherever circuits must not be interrupted.

- Digital Multimeters up to 200 A
- Compact dimensions
- Robust plastic housing
- Multimeter functions
- Safety conditions: IEC1010-1 (2001)
                             CAT II 1000V
                             CAT III 600V
- Incl. ISO Calibration Certificate
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-T 318

PCE-T 318 is an HVAC temperature meter or digital contact thermometer used to measure temperature in laboratory, industrial and heating, ventilation, air conditioning and refrigeration (HVACR) systems and applications. Compatible with IEC751 PT100, PT500 and PT1000 sensors, this platinum resistance temperature detector (RTD) thermometer includes 1 x 4-wire PT100 class A sensor in the delivery contents. Additional sensors sold separately.

 

- Measuring range: -100 ... 300°C / -148 ... 572°F
- Resolution: 0.1°C / 0.18°F
- Accuracy: ± (0.1% of reading + 0.4°C / 0.72°F)

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-P15

PCE-P15 is an HVAC meter or differential pressure manometer used to measure gauge pressure and true differential pressure in pneumatic, hydraulic, compressor and pump installations, valves, tanks and heating, ventilation and air conditioning (HVAC) systems. 11 pressure units are selectable for Imperial and Metric measurement, including bar, mmHg, ozin², kgcm², psi, inH2, kPa, ftH2O|, inHg, cmH2O and mbar.

- Pressure measuring range: 0 to 103.4 kPa / 0 to 15 psi / 0 to 1.034 bar
- Resolution: 6.895 Pa / 0.001 psi / 0.000069 bar
- Accuracy: ± 0.3% of full scale at 25°C / 77°F

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-P30

PCE-P30 is an HVAC meter used to measure gauge and true differential pressure in pneumatic, hydraulic, compressor and pump installations, valves, tanks and heating, ventilation and air conditioning (HVAC) systems. 11 pressure units are selectable for Imperial and Metric measurement, including bar, mmHg, ozin², kgcm², psi, inH2, kPa, ftH2O|, inHg, cmH2O and mbar.


- Pressure measuring range: 0 to 206.8 kPa / 0 to 30 psi / 0 to 2.07 bar
- Resolution: 138 Pa / 0.02 psi / 0.0014 bar
- Accuracy: ± 0.3% of full scale at 25°C / 77°F

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-LCT 3
The HVAC meter is the ideal measuring device to measure leakage currents. This is made possible by the extensive measuring range of the HVAC meter.

Measuring function
- AC current measurement
- DC voltage
- AC voltage
- Resistance
- Continuity test
- Temperature
- Capacity
- Diode test
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-OCM 10
The HVAC meter PCE-OCM 10 is characterized by the OLED display. The OLED display on this HVAC meter allows the display itself to be read in the dark, as it is self-luminous. 

- Measurable up to 600 A
- Clamp with multimeter functions
- OLED display
- NCV function
- TRMS AC A
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-THB 40

PCE-THB 40 is a digital thermometer-hygrometer-barometer with data recording functionality. This compact yet robust data logger detects ambient temperature, relative humidity and atmospheric or barometric pressure. Measurement values are displayed in real time on the large LCD screen and saved to the included SD card as a Microsoft Excel-compatible .XLS file for seamless transfer to a PC or portable computer. Data can also be transferred via an optional USB data cable complete with PC-compatible software (SOFT-LUT-US) for live visualization. Measurement quota can be freely adjusted, with data captured every 5, 10, 30, 60, 120, 300 or 600 seconds, or automatically when there is an alteration of ±1º, ±1% RH or ±1 hPa.


- Ambient temperature range: 0 ... 50°C / 32 ... 122°F
- Relative humidity (RH) range: 10 ... 90% RH
- Barometric pressure range: 10 ... 1100 hPa / 7.5 ... 825 mmHg / 0.29 ... 32.48 inHg

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-P50

PCE-P50 is an HVAC meter or differential pressure manometer used to measure gauge pressure and true differential pressure in pneumatic, hydraulic, compressor and pump installations, valves, tanks and heating, ventilation and air conditioning (HVAC) systems. 11 pressure units are selectable for Imperial and Metric measurement, including bar, mmHg, ozin², kgcm², psi, inH2, kPa, ftH2O|, inHg, cmH2O and mbar.

- Pressure measuring range: 0 to 689.5 kPa / 0 to 100 psi / 0 to 6.9 bar
- Resolution: 689.5 Pa / 0.1 psi / 0.0069 bar
- Accuracy: ± 0.3% of full scale at 25°C / 77°F

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-PCM 3
With the HVAC meter AC currents of up to 1000 A AC can be measured easily. At the same time, voltages of up to 1000V AC / DC can be measured with the HVAC meter. 

Measuring function
- Current measurement AC
- Inrush current AC
- Voltage measurement DC
- Voltage measurement AC
- Frequency measurement
- Frequency measurement current measurement function
- Frequency measurement voltage measurement function
- Duty cycle
- Resistance measurement
- Continuity test
- Capacity measurement
- Diode measurement
- Single-phase power measurement
- Power factor capacitive / inductive
- Harmonics measurement
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-670-ICA
HVAC meter PCE-670-ICA incl. ISO calibration certificate for non-contact measurement of surface temperature. The PCE-670 HVAC meter has a display of the current temperature during the measurement. Within one second you get the surface temperature - the non-contact measuring method even from hot, dangerous or difficult to reach objects.

- IR temperature measuring range: -33 ... 500°C / -27.4 ... 932°F
- Accuracy: ± 2% of v. Mw. or ± 2°C / 3.6°F
- Measured value display optionally in °C or °F
- Measurement spot ratio 9: 1
- Incl. ISO calibration certificate
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-DC2-ICA

HVAC meter for measuring AC/DC current, AC voltage and resistance. This HVAC meter is designed to indirectly detect AC/DC current and ohms. The HVAC meter has white LEDs which illuminate the point of measurement and test the voltage without contact. Small dimensions of this device allow to take measurements in places with limited access. The HVAC meter comes manufacturer calibrated and can optionally be certified according to ISO or standards.


- AC / DC current, voltage and resistance measurement
- 3 2/3-digit LCD display
- Power supply: 2 x 1.5V AAA battery
- Dimensions: 164 x 65 x 32 mm / 6.4 x 2.5 x 1.2 in
- Incl. ISO Calibration Certificate

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-910

PCE-910 is a portable handheld digital HVAC meter or differential pressure manometer used to measure differential pressure in pneumatic, compressor and pump installations, valves, tanks and heating, ventilation and air conditioning (HVAC) systems. The PCE-910 features a dust-proof, splash-resistant housing, allowing the meter to be used under adverse conditions.

- Pressure measuring range: ± 200 kPa / ± 29 psi / ± 2 bar
- Resolution: 100 Pa / 0.0145 psi / 0.001 bar
- 10 measurement units: psi, mbar, inH2O, mH2O, inHg, mmHg, Torr, Pa / kPa, atm, kg/cm²
- Optional PC software with RS-232 cable sold separately as a data transfer accessory

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-DC3-ICA

HVAC meter to determine indirectly, the AC/DC currents with high accuracy.


- AC current (50 / 60 Hz): 2 A  / 1-mA / ± 2.8% + 10 dgt
- DC current: 2 A / 1-mA / ± 3.0% + 10 dgt
- AC overload protection: 100V AC up to 600V AC 50 / 60 Hz
- Incl. ISO Calibration Certificate

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-675-ICA
The HVAC meter PCE-675-ICA incl. ISO calibration certificate has a 13:1 spot-to-spot ratio and can accurately measure surface temperatures and ambient humidity over a very long distance. The HVAC meter is universally applicable.

Measuring function
- Measuring range infrared: -50 ... 550 °C
Thermoelement Type-K: -50 … 850 ºC 
- Measuring range air temperature: -20 … 60 ºC
- Measuring range humidity: 0 … 100 % r.H.
- Measuring range dew point: -20 … 60 ºC
- Measuring range wet bulb temp.: -20 … 60ºC 
- Incl. ISO calibration certificate
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-932

PCE-932 is an easy-to-use, digital, handheld device for high pressure measurement in hydraulic and compressor systems, pumps, tanks and silos in chemical, manufacturing, plastics and HVAC industries. This portable pressure measuring device can be connected to pressure sensors with ranges up to 400 bar (each with a 1.2 m / 3.9 ft connecting cable). Please note: Pressure sensors are sold separately.


- Measuring range: 0 to 400 bar / 0 to 5801 psi, depending on sensor
- Measures system pressure in all media (e.g., gasses, liquids, etc.)
- Offers min, max and hold functionality 


Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-EM 890
The HVAC Meter PCE-EM 890 is an instrument for measuring environmental conditions. Thus, this HVAC meter is ideal for technicians, sailors, farmers and many more people who are dependent on the weather or whose activities are significantly influenced by the weather.

Measurement functions:
- Humidity / temperature
- UV
- Air pressure
- Volume flow
- Dew point
- Wet bulb temperature
- Windchill
- Heat stress index
- Height above sea level
- External temperature over Pt1000
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-917

PCE-917 is a portable handheld digital HVAC meter or differential pressure manometer used to measure differential pressure in pneumatic, compressor and pump installations, valves, tanks and heating, ventilation and air conditioning (HVAC) systems. The PCE-917 features a dust-proof, splash-resistant housing, allowing the meter to be used under adverse conditions.

- Pressure measuring range: ± 700 kPa / ± 101.5 psi / ± 7 bar
- Resolution: 500 Pa / 0.0725 psi / 0.005 bar
- 10 measurement units: psi, mbar, inH2O, mH2O, inHg, mmHg, Torr, Pa / kPa, atm, kg/cm²
- Optional PC software with RS-232 cable sold separately as a data transfer accessory

Manufacturer: PCE Instruments
Test Instruments manufacturer