Industrial Measurement Products and Solutions

Conductivity Meter / Conductivity Tester

Order no.: PCE-CM 41

With the conductivity meter PCE-CM 41 it is possible to measure conductivity value, the amount of all the solid material or dissolved salts  (TDS - Total Dissolved Solids) and the temperature. The conductivity meter PCE-CM 41 is very easy to carry everywhere thanks to its small size. Auto ranges up to 20,000 PPM.


- EC conductivity: 0...2,000 µS/cm  /  0...20 mS/cm
- Salt content TDS: 0...2,000 mg/l (ppm)  /  20,000 mg/l (ppm)
- Temperature: 0.0...+60 °C
- Water resistant (IP 67)

 

Manufacturer: PCE Instruments
Order no.: PCE-PWT 10

The conductivity meter PCE-PWT 10 is a good solution for anyone who wants to check the conductivity of ultrapure water and to accurately determine the salinity of liquids. 

- conductivity: 0 ... 20 µS/cm ...
- salinity: 0,00 ... 10.00 ppt
- temperature: 0 ... 60 °C / 32 ... 140 °F
- automatic temperature compensation
- internal 3-point calibration

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-SM 11

With the conductivity meter PCE-SM 11 conductivity in non-saturated solutions can be quickly and accurately determined. The Conductivity Meter PCE-SM 11 has a high measuring accuracy thanks to the automatic temperature compensation.


- Measurement range:  0.0 ... 12.0 % (weight percentage)
- Accuracy: ± 0.5 %
- Resolution: 0.01 %
- Temperature compensatio: automatic from 0 ... to +50 °C

 

Manufacturer: PCE Instruments
Order no.: PCE-PHD 1

PCE-PHD 1 Multifunction Conductivity Meter is a portable, easy-to-use measuring device with multiple capabilities for inspecting water quality. Offering extraordinary precision at an affordable price, the Multifunction Conductivity Meter is used for laboratory and in situ testing of the pH value, redox, conductivity, salt content, oxygen level, and temperature of water.


- Parameter: pH, Redox, Conductivity, TDS, Salt, Oxygen, Temperature
- Automatic temperature compensation
- Sampling rate of 1 sec.
- SD card memory (16 GB max.)
- Interface: RS-232
- 3 point calibration

 

Manufacturer: PCE Instruments
Order no.: PCE-COM 20

PCE-COM 20 is a portable handheld non-destructive conductivity tester for metals. This non-destructive testing (NDT) device uses eddy current to determine the electrical conductivity of non-ferrous metals such as aluminum and copper.

- Operating frequency: 60 kHz
- Sine wave probe: Ø 14 mm / ≈ 0.55"
- Memory: Up to 500 groups of measurements
- Lift-off and temperature compensation
- Automatic calibration

Manufacturer: PCE Instruments