Industrial Measurement Products and Solutions

Analogue Indicator

Order no.: PCE-EA19I

The analogue indicator or display PCE-EA19I is used to quicky and easily measure currents. This analogue display finds its application in industrial areas. The analogue display can directly measure currents up to 100 A AC and requires no additional power supply.


- Measures up to 100 A AC
- Measuring range: selectable when ordering
- Dimensions: 96 x 96 mm 

 

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-EA19U

The analogue indicator or display PCE EA19U is used simply to measure voltages. The analogue display can be individually configured in various measurement and display areas. The analogue display for AC voltages can measure up to 1000 V directly.


- Measures AC voltage (V AC)
- Measuring range: selectable when ordering
- Dimensions: 96 x 96 mm 

 

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-EP29

The analogue indicator or display PCE-EP 29 is designed to measure simple three-phase-voltages. The analogue display PCE-EP 29 is designed for alternating currents and can measure up to 500 V directly without the need of a transformer (phase-to-phase). The analogue display is designed in CAT III and can be applied to many monitoring tasks of voltages in system control.


- Analogue voltmeter with change over
- 96 x 96 mm
- Panel installation 

 

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-PA39
The analogue indicator PCE-PA39 is designed to monitor AC power. This analogue indicator can be installed onto switch panels. The analogue indicator PCE-PA39 is a moving-coil ammeter. Active power as well as apparent power can be measured by means of this analogue indicator PCE-PA39.

- Moving-coil meter to measure electric power
- 96 x 96 mm
- Panel installation
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-N50F
The analogue indicator PCE-N50F is suitable for panel mounting. This analogue indicator PCE-N50F can be used to indicate the weight, force or torque. The decisive factor here is the type of sensor that is connected to the analogue indicator PCE-N50F.

- Signal input range: 0 ... 20 mV
- Units: g, mN, mlb, Pa, kg, N, Ib, kPa, t, kN, klb, MPa
- For load cells, force sensors, etc.
- Up to 1600 Hz sampling rate
- LCD display
Manufacturer: PCE Instruments
Test Instruments manufacturer