Order no.: Gasman-CL2

The Air Quality Meter Gasman-CLis a unique gas meter which protects against a specific gas, inflammable or toxic. The Air Quality Meter warns with a penetrating alarm and an optical signal (useful in case when there are loud noises in the surroundings) of the existence of dangerous gas concentrations and shows on screen the value of the gas measurement. The Air Quality Meter fulfills all the European and international norms, even ATEX and UL standards.

  • Non-rechargeable, 1-year battery
  • For CL2 (Chlorine)
  • Dust and water resistant - IP 65/67
  • 0 ... 5 ppm
Manufacturer: Crowcon Detection Instruments Ltd.
Test Instruments manufacturer
Order no.: Gasman-CL2

The Gas Leak Detector Gasman-CL2is a unique gas meter which protects against a specific gas, inflammable or toxic. The Gas Leak Detector warns with a penetrating alarm and an optical signal (useful in case when there are loud noises in the surroundings) of the existence of dangerous gas concentrations and shows on screen the value of the gas measurement. The Gas Leak Detector fulfills all the European and international norms, even ATEX and UL standards.


- Non-rechargeable, 1-year battery
- For CL2 (Chlorine)
- Dust and water resistant - IP 65/67
- 0 ... 5 ppm

 

Manufacturer: Crowcon Detection Instruments Ltd.
Test Instruments manufacturer
Order no.: PM1208M

The geiger counter PM1208M combines a geiger counter for gamma rays with the design and functionality of a modern wrist watch and was designed for the continuous monitoring of the environmental radiation level. The degree of radiation is shown on the display of the geiger counter as dose equivalent and dose equivalent rate. If the specified threshold levels are exceeded, the geiger counter gives out an acoustic signal.


- Dose equivalent range: 0.001 - 9999.99 mSv
- Dose equivalent rate range: 0.01 - 9999.99 µSv/h
- Energy range: 0.06 - 1.5 MeV
- Internal memory for up to 500 measurements

 

Manufacturer: UAB "Polimaster Instruments"
Test Instruments manufacturer
Order no.: PM1208M

The radiation detector PM1208M combines a geiger counter for gamma rays with the design and functionality of a modern wrist watch and was designed for the continuous monitoring of the environmental radiation level. The degree of radiation is shown on the display of the radiation detector as dose equivalent and dose equivalent rate. If the specified threshold levels are exceeded, the radiation detector gives out an acoustic signal.


- Dose equivalent range: 0.001 - 9999.99 mSv
- Dose equivalent rate range: 0.01 - 9999.99 µSv/h
- Energy range: 0.06 - 1.5 MeV
- Internal memory for up to 500 measurements

 

Manufacturer: UAB "Polimaster Instruments"
Test Instruments manufacturer
Order no.: PM1208M

The radiation meter PM1208M combines a geiger counter for gamma rays with the design and functionality of a modern wrist watch and was designed for the continuous monitoring of the environmental radiation level. The degree of radiation is shown on the display of the radiation meter as dose equivalent and dose equivalent rate. If the specified threshold levels are exceeded, the radiation meter gives out an acoustic signal.


- Dose equivalent range: 0.001 - 9999.99 mSv
- Dose equivalent rate range: 0.01 - 9999.99 µSv/h
- Energy range: 0.06 - 1.5 MeV
- Internal memory for up to 500 measurements

 

Manufacturer: UAB "Polimaster Instruments"
Test Instruments manufacturer
Order no.: PM1208M

The radioactivity meter PM1208M combines a geiger counter for gamma rays with the design and functionality of a modern wrist watch and was designed for the continuous monitoring of the environmental radiation level. The degree of radiation is shown on the display of the radioactivity meter as dose equivalent and dose equivalent rate. If the specified threshold levels are exceeded, the radioactivity meter gives out an acoustic signal.


- Dose equivalent range: 0.001 - 9999.99 mSv
- Dose equivalent rate range: 0.01 - 9999.99 µSv/h
- Energy range: 0.06 - 1.5 MeV
- Internal memory for up to 500 measurements

 

Manufacturer: UAB "Polimaster Instruments"
Test Instruments manufacturer
Order no.: PCE-MPC 20
The air quality meter PCE-MPC 20 is a particle counter that measures the particles in the atmosphere. The measurable particle sizes in the particle collector are 0.3, 2.5 and 10 μm.

- Measurable particle sizes: PM2.5 / PM10
- Measuring range Mass concentration: 0 ... 2000 μg / m³
- Measurable particle sizes: 0.3, 2.5 and 10 μm
- Display with graphic real-time diagram
- Data memory up to 5000 data sets
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-MPC 20
The air quality monitoring particle counter PCE-MPC 20 is a particle counter that measures the particles in the atmosphere. The measurable particle sizes in the particle collector are 0.3, 2.5 and 10 μm.

- Measurable particle sizes: PM2.5 / PM10
- Measuring range Mass concentration: 0 ... 2000 μg / m³
- Measurable particle sizes: 0.3, 2.5 and 10 μm
- Display with graphic real-time diagram
- Data memory up to 5000 data sets
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-MPC 20
The air sampler PCE-MPC 20 is a particle counter that measures the particles in the atmosphere. The measurable particle sizes in the particle collector are 0.3, 2.5 and 10 μm.

- Measurable particle sizes: PM2.5 / PM10
- Measuring range Mass concentration: 0 ... 2000 μg / m³
- Measurable particle sizes: 0.3, 2.5 and 10 μm
- Display with graphic real-time diagram
- Data memory up to 5000 data sets
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-MPC 20
The airborne particle-counting hygiene meter PCE-MPC 20 is a particle counter that measures the particles in the atmosphere. The measurable particle sizes in the particle collector are 0.3, 2.5 and 10 μm.

- Measurable particle sizes: PM2.5 / PM10
- Measuring range Mass concentration: 0 ... 2000 μg / m³
- Measurable particle sizes: 0.3, 2.5 and 10 μm
- Display with graphic real-time diagram
- Data memory up to 5000 data sets
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-RVI 1

PCE-RVI 1 is an analogue viscometer or dial reading viscometer used in industrial and research applications to measure the viscosity of fluids such as paints, lacquers, inks, pastes, adhesives, plastics, greases and liquid food products. Under identical conditions, test results from an analogue viscometer are as accurate and reproducible as results from a digital viscometer. Thus, the PCE-RVI 1 analogue viscometer offers an affordable solution for viscosity measurement during product and material testing, development, production and quality control.


- Rotational speed: 6, 12, 30, and 60 rpm
- Viscosity range: 10 ... 100,000 mPa.s / cP
- Accuracy: ±5 % full scale (FS) in Newtonian fluids

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-LOC 20
The calibrator PCE-LOC 20 can be used to directly simulate process currents in current loop, mV and mA. This allows the calibrator to be used to set process displays, data loggers, paperless recorders, etc. The calibrator PCE-LOC 20 can be purchased here in our online shop.

- Simultaneous simulation and measurement mode
- For mA, mV and V
- Graphic display
- Supply of sensors possible
- Manual mode & ramp function
- Continuity test
- Data logger function
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-GPA 62

Three-Phase Clamp Meter with network analyzer / power and energy meter with data logger. The three-phase harmonic Analyzer (Graphic Power Quality Analyzer) is used for single-phase or three-phase measurements of active, reactive and apparent power, power factor, phase angle, energy, voltage, current as well as peaks and harmonics. This clamp meter is a perfect tool for all energetic measurements. It is delivered manufacturer calibrated and can be certified to ISO or standards.


- Real-time test, register and measurement of voltage and current (real and effective) 
- Measures power factor and phase angle, frequency, energy, active, reactive and apparent power 
  (single-phase or three-phase in symmetrical networks). 
- Max. conductor diameter: 55 mm / 2.2 in
- Records up to 50,000 records


Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-GPA 62

Clamp on Tester with network Analyzer / Clamp on Tester with data logger. The Clamp on Tester (Graphic Power Quality Analyzer) PCE-GPA 62 is used for single-phase or three-phase measurements of the active, reactive and apparent power, power factor, phase angle, energy, voltage, current as well as peaks and harmonics up to 50? of the harmonic waveform. As all test instruments, the Clamp on Tester is delivered manufacturer calibrated (ISO certification is available optional).


- Real-time test, register and measurement of voltage and current (real and effective) 
- Measures power factor and phase angle, frequency, energy, active, reactive and apparent power 
  (single-phase or three-phase in symmetrical networks). 
- Max. conductor diameter: 55 mm / 2.2 in
- Records up to 50,000 records


Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-DDM 5WI

PCE-DDM 5WI is a rugged crane scale designed to weigh large hanging loads. PCE-DDM 5WI is also a durable digital dynamometer specially crafted to measure strong tensile forces. This high-capacity device is delivered in a protective carrying case and includes two shackles made of heavy-duty aluminum.


- Max. capacity: 5 t / 11,023 lbs / 5,000 kg / 50 kN
- Resolution: 4 lbs / 2 kg / 20 N
- Units of measurement: kg / t / lbs / N / kN
- Does not include remote control

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-LOC 20
The current calibrator PCE-LOC 20 can be used to directly simulate process currents in current loop, mV and mA. This allows the current calibrator to be used to set process displays, data loggers, paperless recorders, etc. The current calibrator PCE-LOC 20 can be purchased here in our online shop.

- Simultaneous simulation and measurement mode
- For mA, mV and V
- Graphic display
- Supply of sensors possible
- Manual mode & ramp function
- Continuity test
- Data logger function
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-GPA 62

The Three-Phase Current Clamp (Graphic Power Quality Analyzer) PCE-GPA 62 is used for single-phase or three-phase measurements of the active, reactive and apparent power, power factor, phase angle, energy, voltage, current as well as peaks and harmonics.


- Real-time test, register and measurement of voltage and current (real and effective) 
- Measures power factor and phase angle, frequency, energy, active, reactive and apparent power 
  (single-phase or three-phase in symmetrical networks). 
- Max. conductor diameter: 55 mm / 2.2 in
- Records up to 50,000 records


Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-LOC 20
The current/voltage data logger PCE-LOC 20 can be used to directly simulate process currents in current loop, mV and mA. This allows the current/voltage data logger to be used to set process displays, data loggers, paperless recorders, etc.

- Simultaneous simulation and measurement mode
- For mA, mV and V
- Graphic display
- Supply of sensors possible
- Manual mode & ramp function
- Continuity test
- Data logger function
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-MPC 20
The dust measuring device PCE-MPC 20 is a particle counter that measures the particles in the atmosphere. The measurable particle sizes in the particle collector are 0.3, 2.5 and 10 μm.

- Measurable particle sizes: PM2.5 / PM10
- Measuring range Mass concentration: 0 ... 2000 μg / m³
- Measurable particle sizes: 0.3, 2.5 and 10 μm
- Display with graphic real-time diagram
- Data memory up to 5000 data sets
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-MPC 20
The dust monitor PCE-MPC 20 is a particle counter that measures the particles in the atmosphere. The measurable particle sizes in the particle collector are 0.3, 2.5 and 10 μm.

- Measurable particle sizes: PM2.5 / PM10
- Measuring range Mass concentration: 0 ... 2000 μg / m³
- Measurable particle sizes: 0.3, 2.5 and 10 μm
- Display with graphic real-time diagram
- Data memory up to 5000 data sets
Manufacturer: PCE Instruments
Test Instruments manufacturer