Industrial Measurement Products and Solutions
Order no.: PCE-C-R1S

Due to its ball bearing, the load cell has a special resistance against lateral forces. The load cell has a strong output signal of approx. 4 mV / V and works with a measurement uncertainty of 0.03% F.S.. The load cell is used especially in harsh environments such as truck scales, train scales, machine weighing, etc..

- Rated load / force F.S.: 0.5 t ... 100 t / 5 kN ... 1 MN
- Corrosion resistant IP67
- Bearing surface ball bearing
- 700 Ohm

 

- Force sensor nominal load selectable! If require 50 t or 100 t please select variant.

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-C-R6S

The flat load cell offers optimum force transmission thanks to its low height and large support surface. The load cell is used especially where there is no space for a complete weighing module. The load cell consists of two components, the lower part being conical and thus able to compensate for smaller tilting movements.

- Rated load / force F.S.: 500 ... 5000 kg / 5000 ... 50000 N
- Corrosion resistant IP67
- 6-wire technology

 

- Force sensor nominal load selectable!

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-DX-AS-ICA

Mechanical shore durometer for measuring hardness of soft elastomer with drag needle. The shore durometer is composed of a single component with a measuring head and a 360º dial. To improve the readability of peak value, the device comes with a drag needle, that ensures the maximum reading can be captured. Once it has been measured, it can be reset to zero. 


- Force of pressure: 0 to 12.5 N
- Penetrating body: 35º (according to Shore A)
- Equipped with drag needle
- Measurement range: 10 ... 90
  (pressure diminishes below 10 and above 90)
- Margin of error: ± 1
- Division of scale: 1
- incl. ISO Calibration Certificate

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-DX-AS-ICA

Mechanical shore hardness tester for measuring hardness of soft elastomer with drag needle. The shore hardness tester is composed of a single component with a measuring head and a 360º dial. To improve the readability of peak value, the device comes with a drag needle, that ensures the maximum reading can be captured. Once it has been measured, it can be reset to zero. 


- Force of pressure: 0 to 12.5 N
- Penetrating body: 35º (according to Shore A)
- Equipped with drag needle
- Measurement range: 10 ... 90
  (pressure diminishes below 10 and above 90)
- Margin of error: ± 1
- Division of scale: 1
- incl. ISO Calibration Certificate

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-FWS 20N-2

This weather station with outside sensor is a real all-rounder. The wireless weather station with outside sensor is easy to assemble based on the instructions provided. You do not have to be a professional to operate the wireless weather station and outside sensors. The weather data of the weather station with outside sensor for different parameters are sent up to 100 meters by radio signal to the main station.


- 3 displays
- Indoor temperature in Celsius or Fahrenheit
- Outside temperature in Celsius or Fahrenheit
- Indoor air humidity / outdoor air humidity
- Air pressure gauge in inHg or hPa
- Absolute or relative air pressure display selectable
- Precipitation indication in mm or inch
- Precipitation indicator for 1 hour, 24 hours, 1 week, 1 month
- Wind speed in mph, km / h, m / s, knots ...
- Wind direction indicator
- Wind chill temperature gauge
- Weather forecast, trend indicator, storm warning
- and much more...

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-HS 50N-ICA

PCE-HS 50N is an affordable digital hanging scale, crane scale, weighing hook or electronic balance that offers quick, easy and accurate weighing of large objects, animals, fish and game. Simply mount the item to be weighed to the hook or snap hook (both hooks are included). Useful for forklift and industrial applications and as well as recreational fishing and hunting, the PCE-HS 50N digital hanging scale features:


- Weight range up to 50 kg / 110 lbs
- Battery operation (3 x AA 1.5 V batteries provided)
- Auto-off, power-saving function (can be deactivated, if preferred)
- incl. ISO Calibration Certificate

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-HS 50N-ICA

PCE-HS 50N are affordable digital hanging scales, crane scale, weighing hook or electronic balance that offers quick, easy and accurate weighing of large objects, animals, fish and game. Simply mount the item to be weighed to the hook or snap hook (both hooks are included). Useful for forklift and industrial applications and as well as recreational fishing and hunting, the PCE-HS 50N digital hanging scales feature:


- Weight range up to 50 kg / 110 lbs
- Battery operation (3 x AA 1.5 V batteries provided)
- Auto-off, power-saving function (can be deactivated, if preferred)
- incl. ISO Calibration Certificate 

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-HS 50N-ICA

PCE-HS 50N is an affordable digital hanging scale, crane scale, weighing hook or electronic balance that offers quick, easy and accurate weighing of large objects, animals, fish and game. Simply mount the item to be weighed to the hook or snap hook (both hooks are included). Useful for forklift and industrial applications and as well as recreational fishing and hunting, the PCE-HS 50N digital hanging scale features:


- Weight range up to 50 kg / 110 lbs
- Battery operation (3 x AA 1.5 V batteries provided)
- Auto-off, power-saving function (can be deactivated, if preferred)
- incl. ISO Calibration Certificate 

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-P30U

The temperature and signal Data Logger with memory PCE-P30U has a wide range of applications. Besides converting various signals, the Data Logger can be used with memory for easy data logging tasks. The Data Logger PCE P30U has an SD memory card and is suitable for use with SD and SDHC cards. These logging test instruments are calibrated by the manufacturer. An ISO calibration certificate is available as an option.


- SD memory card and internal memory
- Universal input
- Output galvanically isolated
- Alarm relay
- Memory size of 534,336 sets of data (internal memory)
  Option: SD card 2 GB

 

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: TD 100

(with 1 roll of thermal paper and 4 batteries) for direct printing of the results (eg for documentation of measuring data on location).

Paper type: Thermal paper

Paper width: 57 mm

Test Instruments manufacturer
Order no.: PCE-RCM 15
The air humidity meter PCE-RCM 15 is specially designed to monitor the quality of indoor air. Among other things, the air humidity meter measures the parameters for PM1, PM2.5, PM10, TVOC, formaldehyde, humidity and temperature. 

Measured quantity:
- Formaldehyde: 0 ... 1,999 mg / m³
- TVOC: 0 ... 9,999 mg / m³
- PM1, PM2.5, PM10: 0 ... 999 μg / m³
- Temperature: -10 ... 45°C / 14 ... 113°F (Only displays in °C) 
- Humidity: 20 ... 99% RH
- 3 different display modes
- Alarm function
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-RCM 15
The air quality meter PCE-RCM 15 is specially designed to monitor the quality of indoor air. Among other things, the air quality meter measures the parameters for PM1, PM2.5, PM10, TVOC, formaldehyde, humidity and temperature. 

Measured quantity:
- Formaldehyde: 0 ... 1,999 mg / m³
- TVOC: 0 ... 9,999 mg / m³
- PM1, PM2.5, PM10: 0 ... 999 μg / m³
- Temperature: -10 ... 45°C / 14 ... 113°F (Only displays in °C) 
- Humidity: 20 ... 99% RH
- 3 different display modes
- Alarm function
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: CAL-SH5-Z
[more]
Manufacturer: Exova Metech GmbH ( Caldi )
Test Instruments manufacturer
Order no.: PCE-PCM 3
With the clamp meter AC currents of up to 1000 A AC can be measured easily. At the same time, voltages of up to 1000V AC / DC can be measured with the clamp meter. 

Measuring function
- Current measurement AC
- Inrush current AC
- Voltage measurement DC
- Voltage measurement AC
- Frequency measurement
- Frequency measurement current measurement function
- Frequency measurement voltage measurement function
- Duty cycle
- Resistance measurement
- Continuity test
- Capacity measurement
- Diode measurement
- Single-phase power measurement
- Power factor capacitive / inductive
- Harmonics measurement
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-PCM 3
With the clamp-on tester AC currents of up to 1000 A AC can be measured easily. At the same time, voltages of up to 1000V AC / DC can be measured with the clamp-on tester. 

Measuring function
- Current measurement AC
- Inrush current AC
- Voltage measurement DC
- Voltage measurement AC
- Frequency measurement
- Frequency measurement current measurement function
- Frequency measurement voltage measurement function
- Duty cycle
- Resistance measurement
- Continuity test
- Capacity measurement
- Diode measurement
- Single-phase power measurement
- Power factor capacitive / inductive
- Harmonics measurement
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-ESM 3/6

The Compact Balance is reliable, easy to transport and handling with double weight range. The Compact Balance is ideal for pharmacies, retail, cafes, restaurants and anywhere else where you need a verified scale.


- Weighing Range: 6 kg
- Verification included
- Backlight
- Display for the client
- LCD dispay with 25 mm digits

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-BS 300-ICA

The Counting Scale is a light, rugged precision balance suitable for different purposes. The removable stainless steel pan allows the laboratory balance to be cleaned easily. The Counting Scale PCE-BS 300 can be used for weighing as well as for piece counting.


- Weighing capacity: Max. 300 g
- Readability (g): 0.01
- Repeatability (g): 0.01
- Incl. ISO calibration certificate

Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-PCM 3
With the current clamp AC currents of up to 1000 A AC can be measured easily. At the same time, voltages of up to 1000V AC / DC can be measured with the current clamp. 

Measuring function
- Current measurement AC
- Inrush current AC
- Voltage measurement DC
- Voltage measurement AC
- Frequency measurement
- Frequency measurement current measurement function
- Frequency measurement voltage measurement function
- Duty cycle
- Resistance measurement
- Continuity test
- Capacity measurement
- Diode measurement
- Single-phase power measurement
- Power factor capacitive / inductive
- Harmonics measurement
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-HDM 15
The digital multimeter PCE-HDM 15 is a universal and robust measuring device. With this digital multimeter, voltages, currents, resistances and many other electrical quantities can be measured. As an additional function with the digital multimeter PCE-HDM 15, a Bluetooth connection can be established with a smartphone.

Multimeter with 11 measuring functions
- AC voltage AC V TRMS
- DC voltage DC V
- AC and DC AC + DC TRMS
- AC AC TRMS
- AC and DC AC + DC TRMS
- DC DC A
- Resistance
- Capacity
- Frequency
- Diode test
- Continuity test
- Thermal image
- Bluetooth interface
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-PCM 3
With the digital multimeter AC currents of up to 1000 A AC can be measured easily. At the same time, voltages of up to 1000V AC / DC can be measured with the digital multimeter. 

Measuring function
- Current measurement AC
- Inrush current AC
- Voltage measurement DC
- Voltage measurement AC
- Frequency measurement
- Frequency measurement current measurement function
- Frequency measurement voltage measurement function
- Duty cycle
- Resistance measurement
- Continuity test
- Capacity measurement
- Diode measurement
- Single-phase power measurement
- Power factor capacitive / inductive
- Harmonics measurement
Manufacturer: PCE Instruments
Test Instruments manufacturer