The Gas Detector Gasman-CO2 is a unique gas meter which protects against a specific gas, inflammable or toxic. The Gas Detector warns with a penetrating alarm and an optical signal (useful in case when there are loud noises in the surroundings) of the existence of dangerous gas concentrations and shows on screen the value of the gas measurement. The Gas Detector fulfills all the European and international norms, even ATEX and UL standards.

- Non-rechargeable, 1-year battery
- For CO₂ (Carbon Dioxide)
- Dust and water resistant - IP 65/67
- 0... 5 % v/v

 

PCE-WMM 50 is a wall-mounted gas detector that uses diffusion to monitor carbon dioxide (CO2) gas levels and ambient temperature (ºC / ºF) indoors. This indoor air quality meter features an alarm-activated potential-free contact that can, for example, activate a fan to reduce CO2 gas concentration in the room.

- CO2 gas measurement range: 0 ... 50,000 ppm
- Temperature measurement range: 0 ... +45 ºC / +32 ... +113 ºF
- IP54-rated enclosure on sensor and remote display units
- 2 adjustable alarm thresholds
- 3- to 4-digit remote display (depends on range)

This gas detector is designed as a cost-effective solution for applications where protection against a specific combustible or toxic gas is required. The Gasman gas detector is a single gas detector.

- Gas detector for flammable gases
- Range: 0...100%
- Alarm: 20%
- Memory for 5000 events
- Data logger for 900 hours of storage with 1 minute intervals
- Interface for calibrating, configuring and reading out the data
- Weight: 130g / 4.5 oz
- incl. charger

- Measuring range: 0 ... 4000 ppm
- Measuring range: 10 ... 90% rh
- Measuring range: 0 ... 50°C / 32 ... 122°F
- Memory on SD card
- 3 parameters of air quality
- CO2, air temperature and humidity

The gas detector is specially designed for long-term monitoring of climatic conditions in, for example, offices, classrooms or lecture halls. The gas detector is equipped with various sensors.

Parameters / Measuring ranges:
- Temperature: 0 ... +50 ºC / 32 ... 122 ºF
- Ambient humidity: 0 ... 100% RH
- Atmospheric pressure: 300 ... 2000 hPa
- CO2: 0 ... 40000 ppm
- 32 GB data storage
- E-paper display with histogram display
- Good / medium / bad rating
- Battery life: approx. 10 months

The Gas Detector Gasman-CO is a unique gas meter which protects against a specific gas, inflammable or toxic. The Gas Detector warns with a penetrating alarm and an optical signal (useful in case when there are loud noises in the surroundings) of the existence of dangerous gas concentrations and shows on screen the value of the gas measurement. The Gas Detector fulfills all the European and international norms, even ATEX and UL standards.

- Non-rechargeable, 1-year battery
- For CO (Carbon Monoxide)
- Dust and water resistant - IP 65/67
- 0... 500 ppm

 

This gas detector is designed to be a cost-effective solution for applications where protection against a specific combustible or toxic gas is required. The Gasman gas detector is a standalone gas detector.

Gas detector for H2S
- Range: 0...100ppm
- Alarm: 5ppm
- Memory for 5000 events
- Data logger for 900 hours of storage with 1 minute intervals
- Interface for calibrating, configuring and reading out the data
- Weight only 130g / 4.5 oz

The Gas Detector Gasman-O2 is a unique gas meter which protects against a specific gas, inflammable or toxic. The Gas Detector warns with a penetrating alarm and an optical signal (useful in case when there are loud noises in the surroundings) of the existence of dangerous gas concentrations and shows on screen the value of the gas measurement. The Gas Detector fulfills all the European and international norms, even ATEX and UL standards.

- Non-rechargeable, 1-year battery
- For NO₂ (Oxygen)
- Dust and water resistant - IP 65/67
- 0... 25% v/v

The Gas Detector PCE-CMM 10-ICA is a multi-function meter for measuring the air quality. This gas detector measures synchronously the CO2 concentration, the air temperature and the humidity.

- Measuring range CO2: 400 ... 5000 ppm
- Measuring range temperature: -10.0 ... 50.0°C / 14 ... 122°F
- Measuring range humidity: 0 ... 99% rh
- Battery operation
- Limit exceeded
- Beep
- incl. ISO Calibration Certificate (for CO2 only)

With its hydrogen-selective sensor, the gas detector can detect the smallest leaks with a very low leak rate. Containers or lines that do not contain hydrogen can also be checked for leaks with the gas detector if they are filled with test gas containing hydrogen and then checked for leaks.

- High sensitivity: > 2 g / year
- Medium sensitivity: > 15 g / year
- Low sensitivity: > 30 g / year - bar display with traffic light function
- Three adjustable sensitivities
- Semi-rigid probe with a length of 40 cm / 15.7"
- Audible and visual alarm

- Fine dust, formaldehyde, humidity, temperature, TVOC
- Particle size channels : PM 2.5 / PM 10
- Measuring range TVOC: 0.00 ... 9.99 mg / m³ (volatile organic compounds)
- Measuring range temperature: -20 ... 70°C / -4 ... 158°F
- Measuring range humidity: 0 ... 100% RH
- Measuring range formaldehyde: 0.00 ... 5.00 mg / m³
- Interface: USB
- For indicative measurements

The innovatively designed CO2 gas detector is a large display for monitoring the indoor air quality. This CO2 gas detector is used specifically to monitor the indoor air quality in large rooms. These include, for example, meeting rooms, lounges, offices or public spaces such as classrooms or kindergartens.

- Measuring range CO2: 0 ... 9999 ppm
- Temperature measuring range: -10.0 ... 100.0 °C
- Humidity measuring range: 0 ... 99% r.h.
- Traffic light bar graph
- Acoustic, adjustable alarm

The Xsafe gas detector is a robust gas sensor for flammable gases in the safe range. The Xsafe gas detector is available in different versions, depending on the gases for which it is to be used. The gas measuring device measures the respective flammable gases with the help of an integrated pellistor.

- Different versions available
- For use in safe areas
- Detection by pellistor
- 3-wire 4 ... 20 mA or mV output

With the gas detector you can ensure the right climate in your office. The gas detector measures the CO2 content of the air, the relative humidity and the room temperature. The gas detector shows carbon dioxide concentrations up to 9999 ppm, temperatures from -10… 50 °C, and relative humidity values from 20… 95%.

- Large CO2 measuring range up to 9999 ppm
- Traffic light function for carbon dioxide
- Measures temperature and humidity
- Network operation
- Suitable for classrooms, offices, lecture halls
- incl. ISO Calibration Certificate (for CO2 only)

- Temperature measuring range: -10 ... 50 ° C
- Large CO2 measuring range up to 5000 ppm
- Traffic light function for carbon dioxide
- Measures humidity
- 5 h graph for long-term monitoring
- Battery and mains operation
- Suitable for classrooms, nurseries/kindergartens, lecture halls
- incl. ISO calibration certificate (for CO2 only)

The gas detector has a CO² measuring range of 0 ... 9999 ppm. In addition to the carbon dioxide measurement, the gas detector also has a carbon monoxide (CO) sensor with a measuring range of 0 ... 1000 ppm and a temperature and humidity sensor.

- Carbon monoxide (CO): 0 … 1000 ppm
- Carbon dioxide (CO²): 0 … 9999 ppm
- Temperature: 0 … 50 °C / 32 … 122 °F
- Humidity: 0 … 100% RH
- Data memory for 5000 measuring points
- Data export CSV
- Power supply: rechargeable battery

- Measuring range CO2: 400 ... 5000 ppm
- Measuring range temperature: -10.0 ... 50.0°C / 14 ... 122°F
- Measuring range humidity: 0 ... 99% rh
- Battery operation
- Limit exceeded
- Beep