This gas detector is designed as a cost-effective solution for applications where protection against a specific combustible or toxic gas is required. The Gasman gas detector is a single gas detector.

- Gas detector for flammable gases
- Range: 0...100%
- Alarm: 20%
- Memory for 5000 events
- Data logger for 900 hours of storage with 1 minute intervals
- Interface for calibrating, configuring and reading out the data
- Weight: 130g / 4.5 oz
- incl. charger

The Xsafe gas detector is a robust gas sensor for flammable gases in the safe range. The Xsafe gas detector is available in different versions, depending on the gases for which it is to be used. The gas measuring device measures the respective flammable gases with the help of an integrated pellistor.

- Different versions available
- For use in safe areas
- Detection by pellistor
- 3-wire 4 ... 20 mA or mV output

This gas leak detector is designed as a cost-effective solution for applications where protection against a specific combustible or toxic gas is required. The Gasman gas leak detector is a single gas detector.

- Gas detector for flammable gases
- Range: 0...100%
- Alarm: 20%
- Memory for 5000 events
- Data logger for 900 hours of storage with 1 minute intervals
- Interface for calibrating, configuring and reading out the data
- Weight: 130g / 4.5 oz
- incl. charger

The Xsafe gas leak detector is a robust gas sensor for flammable gases in the safe range. The Xsafe gas leak detector is available in different versions, depending on the gases for which it is to be used. The gas measuring device measures the respective flammable gases with the help of an integrated pellistor.

- Different versions available
- For use in safe areas
- Detection by pellistor
- 3-wire 4 ... 20 mA or mV output

- Measuring range: 0 ... 4000 ppm
- Measuring range: 10 ... 90% RH
- Measuring range: 0 ... 50 °C / 32 ... 122 °F
- Memory on SD card
- 3 parameters of air quality
- CO2, air temperature and humidity
- incl. ISO Calibration Certificate (for CO2 only)

With its hydrogen-selective sensor, the gas detector can detect the smallest leaks with a very low leak rate. Containers or lines that do not contain hydrogen can also be checked for leaks with the gas detector if they are filled with test gas containing hydrogen and then checked for leaks.

- High sensitivity: > 2 g / year
- Medium sensitivity: > 15 g / year
- Low sensitivity: > 30 g / year - bar display with traffic light function
- Three adjustable sensitivities
- Semi-rigid probe with a length of 40 cm / 15.7"
- Audible and visual alarm

This CO2 Analyser Gas-Pro-3 can gauge with its sensors a maximum of five different gases. Because of this versatility, the CO2 Analyser Gas-Pro-3 is ideal for use in a variety of applications, such as: near canals, sewage treatment plants, drains, wastewater facilities, dumps/landfills, chemical/oil plants, shipping ports and more.

- Purpose: Personal protection
- Sensor type: CO / CO2 / H2S / O2 / CH4
- Memory: Yes
- Interface: USB
- Includes suction pump
- Other gas sensors available upon request. Please email jmu@pce-
  instruments.com (UK) or rhe@pce-instruments.com (US) for details

This Air Quality Meter Gas-Pro-3 can gauge with its sensors a maximum of five different gases. Because of this versatility, the Air Quality Meter Gas-Pro-3 is ideal for use in a variety of applications, such as: near canals, sewage treatment plants, drains, wastewater facilities, dumps/landfills, chemical/oil plants, shipping ports and more.

- Purpose: Personal protection
- Sensor type: CO / CO2 / H2S / O2 / CH4
- Memory: Yes
- Interface: USB
- Includes suction pump
- Other gas sensors available upon request. Please email jmu@pce-
  instruments.com (UK) or rhe@pce-instruments.com (US) for details

The Gas Detector Gasman-O2 is a unique gas meter which protects against a specific gas, inflammable or toxic. The Gas Detector warns with a penetrating alarm and an optical signal (useful in case when there are loud noises in the surroundings) of the existence of dangerous gas concentrations and shows on screen the value of the gas measurement. The Gas Detector fulfills all the European and international norms, even ATEX and UL standards.

- Non-rechargeable, 1-year battery
- For NO₂ (Oxygen)
- Dust and water resistant - IP 65/67
- 0... 25% v/v

- Measuring range: 0 ... 4000 ppm
- Measuring range: 10 ... 90% rh
- Measuring range: 0 ... 50°C / 32 ... 122°F
- Memory on SD card
- 3 parameters of air quality
- CO2, air temperature and humidity

PCE-WMM 50-ICA is a wall-mounted carbon dioxide gas leak detector that uses diffusion to monitor carbon dioxide (CO2) gas levels and ambient temperature (ºC / ºF) indoors. This indoor carbon dioxide gas leak detector features an alarm-activated potential-free contact that can, for example, activate a fan to reduce CO2 gas concentration in the room.

- CO2 gas measurement range: 0 ... 50,000 ppm
- Temperature measurement range: 0 ... +45 ºC / +32 ... +113 ºF
- IP54-rated enclosure on sensor and remote display units
- 2 adjustable alarm thresholds
- 3- to 4-digit remote display (depends on range)
- incl. ISO Calibration Certificate

- Fine dust, formaldehyde, humidity, temperature, TVOC
- Particle size channels : PM 2.5 / PM 10
- Measuring range TVOC: 0.00 ... 9.99 mg / m³ (volatile organic compounds)
- Measuring range temperature: -20 ... 70°C / -4 ... 158°F
- Measuring range humidity: 0 ... 100% RH
- Measuring range formaldehyde: 0.00 ... 5.00 mg / m³
- Interface: USB
- For indicative measurements

The gas detector is specially designed for long-term monitoring of climatic conditions in, for example, offices, classrooms or lecture halls. The gas detector is equipped with various sensors.

Parameters / Measuring ranges:
- Temperature: 0 ... +50 ºC / 32 ... 122 ºF
- Ambient humidity: 0 ... 100% RH
- Atmospheric pressure: 300 ... 2000 hPa
- CO2: 0 ... 40000 ppm
- 32 GB data storage
- E-paper display with histogram display
- Good / medium / bad rating
- Battery life: approx. 10 months

PCE-WMM 50 is a wall-mounted gas leak detector that uses diffusion to monitor carbon dioxide (CO2) gas levels and ambient temperature (ºC / ºF) indoors. This indoor air quality meter features an alarm-activated potential-free contact that can, for example, activate a fan to reduce CO2 gas concentration in the room.

- CO2 gas measurement range: 0 ... 50,000 ppm
- Temperature measurement range: 0 ... +45 ºC / +32 ... +113 ºF
- IP54-rated enclosure on sensor and remote display units
- 2 adjustable alarm thresholds
- 3- to 4-digit remote display (depends on range) 

 

This Carbon Dioxide Meter Gas-Pro-3 can gauge with its sensors a maximum of five different gases. Because of this versatility, the Carbon Dioxide Meter Gas-Pro-3 is ideal for use in a variety of applications, such as: near canals, sewage treatment plants, drains, wastewater facilities, dumps/landfills, chemical/oil plants, shipping ports and more.

- Purpose: Personal protection
- Sensor type: CO / CO2 / H2S / O2 / CH4
- Memory: Yes
- Interface: USB
- Includes suction pump
- Other gas sensors available upon request. Please email jmu@pce-
  instruments.com (UK) or rhe@pce-instruments.com (US) for details

This CO2 Analyser Gas-Pro-2 can gauge with its sensors a maximum of five different gases. Because of this versatility, the CO2 Analyser Gas-Pro-2 is ideal for use in a variety of applications, such as near canals, sewage treatment plants, drains, wastewater facilities, dumps and landfills, chemical and oil plants, shipping ports and more.

- Purpose: Personal protection
- Sensor type: CO / H2S / O2 / CH4
- Memory: Yes
- Interface: USB
- Includes suction pump
- Other gas sensors available upon request. (Please email jmu@pce-instruments.com (UK) or jwe@pce-instruments.com (US) for details!)

This Air Quality Meter Gas-Pro-2 can gauge with its sensors a maximum of five different gases. Because of this versatility, the Air Quality Meter Gas-Pro-2 is ideal for use in a variety of applications, such as near canals, sewage treatment plants, drains, wastewater facilities, dumps and landfills, chemical and oil plants, shipping ports and more.

- Purpose: Personal protection
- Sensor type: CO / H2S / O2 / CH4
- Memory: Yes
- Interface: USB
- Includes suction pump
- Other gas sensors available upon request. (Please email jmu@pce-instruments.com (UK) or jwe@pce-instruments.com (US) for details!)