The PCE-CL 20 is a HVAC meter or locator used to detect live and voltage-free electrical wires. This HVAC meter also can be used to locate metallic and non-metallic gas or water pipes, identify short circuits, and follow lines inside walls or under flooring.

- Output signal: 125 kHz
- Compatible with one- or two-pole circuits
- Automatic, manual and UAC measuring modes 

 

The original BIA class 1 closing force measuring device is an electronic closing force measuring device for rail vehicle and bus doors and sliding steps. The elaborate design combines precision with practical robustness and ensures accurate measured values even after years of use in harsh environments.

- Measuring range: 25 ... 310 N
- Stiffness: 10 N/mm
- Accuracy: +/- 3N or 3% of reading
- Memory for 100 measurements
- Sensor and PC interface
- Applicable standards: EN 14752:2005, VDV 111, VDV 157, 2001/85/EG
- incl. evaluation software PinchPilot
- incl. display unit SEB2
- incl. ISO calibration certificate

The humidity detector is intended for stationary measurement of relative humidity and temperature and direct display on a large display. This humidity detector consists of an LED display (100 mm high) and is protected according to IP 54.

- Temperature measuring range: 0 ... +60 °C (Celsius only)
- Humidity measuring range: 10 ... 95 % RH
- Up to 50 m (164 ft) reading distance
- External sensor (wired)

- Measuring range: 0 ... 4000 ppm
- Measuring range: 10 ... 90% RH
- Measuring range: 0 ... 50 °C / 32 ... 122 °F
- Memory on SD card
- 3 parameters of air quality
- CO2, air temperature and humidity
- incl. ISO Calibration Certificate (for CO2 only)

- Measuring range: 0 ... 4000 ppm
- Measuring range: 10 ... 90% rh
- Measuring range: 0 ... 50°C / 32 ... 122°F
- Memory on SD card
- 3 parameters of air quality
- CO2, air temperature and humidity

- Measuring range cable length: 5 ... 3000 m / 16.4 ... 9842.5 ft
- Measurement Units: m, ft
- Resolution: 0.1 m / 0.3 ft
- Measuring principle: time domain reflectometer
- 20 pre-set cable types

- Measuring range: 0 ... 4000 ppm
- Measuring range: 10 ... 90% RH
- Measuring range: 0 ... 50 °C / 32 ... 122 °F
- Memory on SD card
- 3 parameters of air quality
- CO2, air temperature and humidity
- incl. ISO Calibration Certificate (for CO2 only)

With its hydrogen-selective sensor, the leak detector can detect the smallest leaks with a very low leak rate. Containers or lines that do not contain hydrogen can also be checked for leaks with the leak detector if they are filled with test gas containing hydrogen and then checked for leaks.

- High sensitivity: > 2 g / year
- Medium sensitivity: > 15 g / year
- Low sensitivity: > 30 g / year - bar display with traffic light function
- Three adjustable sensitivities
- Semi-rigid probe with a length of 40 cm / 15.7"
- Audible and visual alarm

With its hydrogen-selective sensor, the gas detector can detect the smallest leaks with a very low leak rate. Containers or lines that do not contain hydrogen can also be checked for leaks with the gas detector if they are filled with test gas containing hydrogen and then checked for leaks.

- High sensitivity: > 2 g / year
- Medium sensitivity: > 15 g / year
- Low sensitivity: > 30 g / year - bar display with traffic light function
- Three adjustable sensitivities
- Semi-rigid probe with a length of 40 cm / 15.7"
- Audible and visual alarm