[zoom]
[zoom]
[zoom]
[zoom]
[zoom]
£ 599.00
The PCE-DDA 10 Hardness Tester is an ergonomic device to check Shore hardness in gum, plastic and other non-metallic materials. It has been designed with a very high quality. The PCE-DDA 10 Hardness Tester is mainly used for soft gums, elastomers, natural rubber, neoprenes, casting resin, white PVC, leather, etc. If the material thickness is not enough, it should be layered and tightened on the back with the same material in order to increase its thickness.
| Hardness | |
| Measuring range | 0 ... 100 Shore A |
| Resolution | 0,1 Shore A |
| Accuracy | <±1 Shore A |
| General technical data | |
| Measuring functions | MAX, Average value |
| Measuring principle | Spring load |
| Storage medium | Internal memory |
| Storage capacity | 500 Measurements |
| Interface | Mini-USB |
| Standard(s) | GB/T 531.1, ISO7619-1, ASTM D 2240 |
| Operating time | 20 h |
| Charging time | 3 h |
| Impact device | D-type |
| Dimensions | Indentor / geometry: - Spring pin diameter: 1.25 ± 0.1 mm - Ball diameter: 0.79 ± 0.03 mm - Cone angle (tip angle): 35 ± 0.25° |
| Menu language | English, English (GB) |
| Protection class (device) | IP20 |
| Power supply | 3.6V |
| Connector type | Device-europlug |
| (Rechargeable) battery | 3 x 1,2 V AAA rechargeable battery , Nickel-metal hydride battery |
| Capacity | 1200 mAh |
| Operating conditions | 0 ... 50 °C , 20 ... 85 % RH |
| Storage conditions | 0 ... 50 °C , 20 ... 85 % RH |
| Dimensions ( L x W x H ) | 153 x 50 x 29 mm |
| Weight | 170 g |
