Industrial Measurement Products and Solutions

Cable Fault Meter

Order no.: PCE-LT1

Cable Fault Meter for quickly testing networks, with functions to also be used as a multimeter.

- Measures AC and DC, alternate and continuous resistance
  and resistance

- Continuity tester with buzzer and diode tester
- Safety: CAT II 1000 V, EN-61010-1
- Auto shut-off
- Manual or automatic testing of individual connectors
- For testing cables, connections and cables that run within wall


Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-191 CB

PCE-191 CB is a handheld, portable wire tracer, cable detector or cable fault meter used for locating wires and cables hidden behind walls and insulation.

- Power range: 220 to 240 V AC
- Frequency range: 50 / 60 Hz
- Acoustic alarm 


Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-180 CBN

PCE-180 CBN is a handheld, portable, battery-powered wire tracer or cable locator that consists of an amplifier probe and acoustic signal or tone generator. This locating device is designed to detect wires or cables hidden behind walls or insulation.

- Uses an acoustic signal to detect wires and cables, including
  network and coaxial cables
- Features a 3-position toggle switch (and 3-color LED) for line
  polarity, continuity and voltage testing

- Comes with red and black test leads with alligator clips 


Manufacturer: PCE Instruments
Order no.: PCE-CLT 10
The cable fault meter PCE-CLT 10 is a multifunctional device which enables high accuracy and fast measurement results. If used appropriately, the cable fault meter can be used to measure cables that have already been installed and are still to be installed.

- Measuring range cable length: 5 ... 3000 m / 16.4 ... 9842.5 ft
- Measurement Units: m, ft
- Resolution: 0.1 m / 0.3 ft
- Measuring principle: time domain reflectometer
- 20 pre-set cable types
Manufacturer: PCE Instruments
Test Instruments manufacturer
Order no.: PCE-CL 10

PCE-CL 10 is a cable fault meter that uses the conductive method to detect metal pipes or pipe tracer wires. With PCE-CL 10, you also can locate power cables, lines, circuits, short circuits and ground points, as well as test protective tubing and coaxial cables. To perform these functions, it is not necessary to disconnect the power. Location can be identified in floors, ceilings, walls and the ground, even behind concrete and brick.

- Operating temperature / humidity: 0 ... +40 ºC or
  +32 ... +104 ºF / max. 80% rh
- Storing temperature / humidity: -20 ... +60 ºC or
  -4 ... +140 ºF/ max. 80% rh
- Max. Voltage: 400 VAC (0 - 60 Hz) / 400 V DC


Manufacturer: PCE Instruments
Order no.: PCE-CL 20

PCE-CL 20 is a cable fault meter or locator used to detect live and voltage-free electrical wires. This cable detector also can be used to locate metallic and non-metallic gas or water pipes, identify short circuits, and follow lines inside walls or under flooring.

- Output signal: 125 kHz
- Compatible with one- or two-pole circuits
- Automatic, manual and UAC measuring modes 


Manufacturer: PCE Instruments