- Current Converter

The PCE-P20Z transmitter is used to convert a measured current into a standard signal. This makes it possible to determine the most diverse currents with the transmitter.

- Input: Alternating current
- Various supply voltages
- For direct or indirect current measurement
- Current transformer can be connected
- With voltage output or current output

Note: This item must be configured before ordering!

- Over 100 combinations pre-selected
- Converts analogue input range
- Completely galvanic isolation
- Power supply 18 ... 265V AC / DC

The PCE-P20H transducer measures DC currents up to ± 5 A DC and converts them into a standard signal. Depending on the version, the PCE-P20H transducer can measure 1 A or 5 A DC and outputs a 4 ... 20 mA or 0 ... 10 V standard signal. Depending on the model, the supply voltage of the transducers is either 85 ... 253 V AC / DC or 20 ... 40 V AC / DC.

 

The current signal converter has an adjustable measuring range of 0… 600 V AC/DC and can therefore measure a wide variety of voltages. For example, it is possible to connect the transmitter to the supply line in order to monitor the applied voltage.

- Measuring range 0 ... 600 V AC/DC
- Active and passive output signal
- Display and keypad for configuration
- Frequency measurement
- DIN rail mounting
- Display

The PCE-P30H current signal converter is used for direct voltages and currents between 12 V ... 1000 V DC or currents up to 150 A via separate shunts. The signal converter can convert the measured signals into an analog standard signal. Furthermore, the measured values can be distributed to process control systems via Modbus RTU.

- SD card memory and internal memory
- DC input for voltage and current via shunts (shunt resistor)
- Output galvanically isolated
- Alarm relay
- Modbus interface
- LC display
- 35 mm mounting rails