2 year Warranty
The pressure transmitter PCE-DMU 40 can be used for relative and absolute pressure measurements. The pressure transmitter can be used for gases, water as well as fuels and oils.
- max. 600 Bar
- Media: gases, water as well as fuels and oil
- Output: 4 ... 20 mA / 0 ... 10 V (selectable)
- Pressure type: Absolute or Relative (selectable)
- Membrane: stainless steel
- Accuracy: 0.1 % / 0.25 % FSO
The pressure transmitter PCE-DMU 10 can be used for gases, water as well as fuels and oils. The pressure transmitter can be used for relative and absolute pressure measurements.
- max. 400 Bar
- Media: gases, water as well as fuels and oil
- Output: 4 ... 20 mA / 0 ... 10 V (selectable)
- Pressure type: Absolute or Relative (selectable)
- Membrane: ceramic
- Accuracy: 0.5 % FSO
- Measurement and conversion of DC currents up to ± 5 A
- Output: 4 ... 20 mA or 0 ... 10 V Standard signal
- Various supply voltages
- Compact DIN rail mounting
- Measurement and conversion of DC voltages up to 400 V
- Output: 4 ... 20 mA or 0 ... 10 V Standard signal
- Various supply voltages
- Compact DIN rail mounting
The PCE-P20Z measuring transducer measures voltages up to 600 V AC and converts this into a standard signal. Depending on the design, the PCE-P20U-I transducer can measure voltages up to 250 V AC, 400 V AC or 600 V AC and outputs a 4 ... 20 mA standard signal. Depending on the model, the supply voltage of the transducers is either 85 ... 253 V AC / DC or 20 ... 40 V AC / DC.
- RMS Measurement of voltages up to 600 V AC
- Input: AC voltage
- Output: 4 ... 20 mA or 0 ... 10 V Standard signal
- Various supply voltages
Note: This item must be configured before ordering!
The PCE-P20Z transmitter is used to convert a measured current into a standard signal. This makes it possible to determine the most diverse currents with the transmitter.
- Input: Alternating current
- Various supply voltages
- For direct or indirect current measurement
- Current transformer can be connected
- With voltage output or current output
Note: This item must be configured before ordering!
Clamp on Tester to test leakage / RMS measurement / continuity and resistance test. The Clamp on Tester can measure leakage currents which appear when current flows through electrical conductors which are not designed for conduction current. The Clamp on Tester, as all test instruments, is delivered manufacturer calibrated, but can additionally be certified to ISO.
- Measures current up to 100 A
- Measures voltage up to 600 V
- Measures resistance up to 400 O
- Test cables are included
Clamp Meter to test leakage / RMS measurement / continuity and resistance test. With the leakage Clamp Meter it is possible to measure leakage current with a range up to 100 A. The Clamp Meter can measure leakage current while current flows through electrical conductors that are not designed for conduction current. The leakage Clamp Meter is delivered manufacturer calibrated and can additionally be certified to ISO.
- Measures current up to 100 A
- Measures voltage up to 600 V
- Measures resistance up to 400 Ohms
- Test cables are included