Dynamometer PCE-DFG NF 10K Incl. ISO Calibration Certificate

Order no.: PCE-DFG NF 10K
ISO Calibration

£ 1,219.00
£ 1,462.80
price ex. (VAT / delivery)
Delivery time: 10 - 14 days
PCE-DFG NF 10K Dynamometer
ith external load cell, USB interface and PC software

The dynamometer with an external load cell is designed for the measurement of compressive forces at hard-to-reach measuring points. The pressure cell is connected to the dynamometer by a sensor cable of approx. 3 m length and thanks to the small cell dimensions it ensures a versatile application. The dynamometer or the load cell has on the bottom of several threaded holes that allow a firm installation.

The dynamometer can operate at a sampling rate of up to 1600 Hz. The sampled measured values ​​are displayed as an instantaneous value, as well as in a graph trace directly in the dynamometer.

The measurements can be stored in the internal memory or transmitted via USB interface with the included software with a maximum of 800 Hz as a live measurement.

The PEAK Hold function allows freezing of the highest measured value in the dynamometer until this value is exceeded or cleared.

The dynamometer offers the option of storing two limit values, which are continuously compared with the instantaneous value. When exceeding or falling below these limits, a signal in the display of the dynamometer, as well as a reaction via external interfaces, which can be used for example for the control of a testing machine.

- USB interface
- Graphic display
- Fast response time
- PC software
- Memory for 100 measurements
- Incl. ISO calibration certificate
Measuring range 0 ... 10 kN / 10,000 N / 1,000 kg / 2,245 lbs
Resolution 1 N / 0.22 lb
Accuracy ± 0.5% of the measuring range
Measurement units N, kg, lb, kPa
Display 2.8" TFT graphic display
Alarm Modes Inside, Outside, Crack, Shutdown
Sampling rate 6 ... 1600 Hz
Storage 100 measurements
Power supply NiMH battery, 6V / 1600-mAh
Battery life About 10 hours
Power adapter / charging adapter       12V / 1A
Outputs Interface: USB switching output: 12V / 50-mA
Protection class IP 54
Operating and storage conditions    -10 ... 50°C / -14 ... 122°F
5 ... 95% rh non-condensing
Dimensions pressure cell Ø 32 mm / H 16 mm / M5 thread
(see technical drawing)
Cable length pressure cell About 3 m / 9.8 ft
Dimensions 200 x 97 x 42 mm / 7.9 x 3.8 x 1.7 in
mass 540 g / 1.2 lbs

1 x PCE-DFG NF 10K Dynamometer
1 x Pressure cell (depending on model)
1 x USB cable
1 x Charger
1 x PC software
1 x User manual
1 x ISO calibration certificate