The Dynamometer EDxtreme is built with the best materials and designed with cutting-edge features like radio control. The Dynamometer EDx is clearly the choice for reliability in any environment – in-plant or out on the job site.
- Measuring range: 200,000 kg / 550,000 lbf
- Resolution: 50 kgf / 200 lbf
- Accuracy: 0.3%
- Display Type: Digital
- Sensor: Internal
- Interface: Funk
Enclosure: Designed to NEMA4X/IP55. Suitable for continuous outdoor use.
Body protection: Aluminum and alloy steel capacities are powder coated
Bearings: Unmatched repeatability attained by needle bearings in shackle pin holes up to EDx-10K. Precision machined shackles act as inner race.
Shackles: Forged industry standard anchor shackle bows, galvanized finish. Models up to EDx-10K use precision machined shackle pin. Higher capacities use forged pin.
Display: 128 x 64 dot-graphic LCD display shows up to 6 digits 1.0” (26 mm) high plus annunciators and softkeys. Digits are .11 inches (7mm) thick for unmatched readability.
Display update rate: 2 times per second.
Connector: Recessed sealed connector may be used for direct serial communications or connection to a Communicator remote.
RS-232 / RS-485 communication: Print or extract data easily. Continuous output can drive a scoreboard. Configurable poll character.
Calibration: Traceable to the National Institute of Standards and Technology. Certificate included with curve of readings. Passes only with three consecutive confirming runs, with all points in specification.
Battery life: 320 hours typical use with two C-cell alkaline batteries. 40 hours typical with Radio Link system. Operating temperature: -4° F to 140° F (-20° to 60° C)
Included with instrument: Shipping/storage crate(s), batteries, manual and certificate of calibration.
Options: 2.4 GHz radio board. Display backlight.
FCC Certified: For unlicensed low power devices. No radio licensing or permits required for normal operation.* (In the US and Canada. Check local ordinances in other countries.)
Frequency: 2.4 GHz spread-spectrum operates between 2.402 – 2.478 GHz. Continuously and automatically changes frequencies many times per second for consistent, reliable communications.
Output level: 10 mW (20 dBm)
Display update rate: 2 times per second with single dynamometer. Multi-instrument networks result in reduced updates.
Number of networks: 63 remotes can operate independently in the same airspace with unique channels.
Number of links remote can control: Up to 15 addresses are available per network channel.
Configuration: Address and Network channels are front-panel configurable.
Antenna: Integral antenna.
Range: Open-air – Up to 300 feet, line-of-sight. Indoors – Dependent upon installation site with 150 feet common.
Approval: FCC ID: KQL-PKLR2400. CAN ID: CAN2268391158A