Current Clamp Adapter CA-Y1N

Order no.: CA-Y1N

£ 156.00
£ 187.20
CA-Y1N
price ex. (VAT / delivery)
Delivery time: 1-2 working days

CA-Y1N Current Clamp Adapter
for multimeters and oscilloscopes / up to 600 A AC TRMS up to 10 kHz / current and voltage output / for small to medium-sized streams / very accurate

The Y-Series Current Clamp Adapter is used to measure AC up to 600 A, depending on the model. The output of the Current Clamp Adapter can be either current or voltage, AC or DC. The Current Clamp Adapter can be connected to both an oscilloscope or a multimeter. This universally applicable Current Clamp Adapter does not need its own power supply, just connect the instrument with the test leads to the meter, removing the need to worry about the battery charge. The Current Clamp Adapter can safely detect current in the range from 5 Hz ... 10 kHz.

There are two types of Y series clamps available:
The first acts as a current transformer (ratios of 100:1 or 1000:1), giving an output current that may be read by a multimeter, logger, or other suitable devices with appropriate current calibres. The other kind of Y-Series clamp has a DC voltage output proportional to the AC current measured, allowing instruments without current calibres to measure, display, and record currents on a DC voltage calibre. Click here for more technical information on the Y-Series Current Clamp Adapters.


- Up to 600 A AC measurable
- Cable with angle plug
- 30 mm / 1.2 in cable diameter
- Selector switch
- AC / DC current or voltage output
- 5 Hz ...10 kHz measurable
- Autonomous power clamp adapter
- Adapter for multimeter and oscilloscope


Technical Specification
Model Y1N Y3N Y4N Y7N
Measuring range 4 A ... 600 A AC 4 A ... 600 A AC 4 A ... 600 A AC 1 A ... 500 A (1200 A peak)
Accuracy 3% 3% 2% ≤2%
Conversion ratio (E:A) 1000 : 1 100 : 1 1 A : 1 mV DC 1 A : 1 mV AC
Output Signal 1 mA AC / A AC 10 mA AC / A AC 1 mV DC / A AC 1 mV AC / A AC (0.5 V for 500 A)
Bandwidth 48 Hz ... 1 kHz 48 Hz ... 1 kHz 48 Hz ... 1 kHz 5 kHz ... 10 kHz
Load impedance 5 Ω max 0.1 Ω max >100 kΩ max ≤100 Ω max / 4.7 nF
Output 1.5 m / 4.9 ft cable, 4 mm / 0.2 in male safety plugs 2 m / 6.6 ft coaxial cable, BNC plug
Max. jaw opening 33 mm / 1.3 in
Clamping capacity Cable: Ø 30 mm / 1.2 in
Busbar: 63 mm x 5 mm / 2.5 in x 0.2 in
Environmental conditions Operating: -15° C ... +50° C / +5° F ... +122° F.
Storage: -40° C ... +85° C / -40° F ... +185° F
Casing protection IP 20 in accordance with IEC 529
Dimensions 66 mm x 195 mm x 34 mm / 2.5 in x 7.6 in x 1.3 in
Weight 420 g / 14.8 oz

Delivery Contents
1 x CA-Y1N Current Clamp Adapter
1 x User manual