Condition Monitoring Flaw Detector PCE-USC 30

Order no.: PCE-USC 30
£ 4,445.00
£ 5,334.00
price ex. (VAT / delivery)
Delivery time: 1-2 working days
Portable condition monitoring flaw detector for NDT / NDT testing of surfaces / Coating thickness measurement using eddy current / Conductivity measurement of metals according to IACS / Material sorting

The condition monitoring flaw detector is used in non-destructive material testing. With the eddy current testing device, surface defects and near-surface defects can be made visible. Eddy current testing is an electrical method for testing electrically conductive materials. In the eddy current test, a probe charged with alternating voltage is placed on an electrically conductive test piece. The magnetic field lines generated perpendicular to the workpiece surface induce circular eddy currents close to the surface, creating secondary magnetic fields in the test piece. The secondary fields counteract the primary fields and measurably change them in terms of amplitude and phase. Inhomogeneities and workpiece defects change the eddy current curves and the permeability of the material and thus also the secondary fields. In this way, defects close to the surface can be located and classified.

The condition monitoring flaw detector is designed for corresponding NDT material tests and can also be used for conductivity measurement and layer thickness determination.

The ergonomic design of the condition monitoring flaw detector, a weight of less than 1 kg, a battery life of approx. 8 hours, a large selection of probes to cover a wide frequency range up to 3.5 MHz, as well as software for generating reports are good prerequisites for effective and pleasant work.

The condition monitoring flaw detector is therefore ideally suited for non-destructive material testing in the aerospace sector for component testing of e.g. turbine blades or bores, for welding seam testing and crack testing, for pipeline and container testing in the chemical, oil and gas industry or in the field of mechanical engineering for quality control of semi-finished products, sheet, strip products or individual components. The testing of material properties is also possible via a microstructure comparison, so that checks for mix-ups can also be carried out.

- Large frequency range
- 4.3" large colour display (TFT)
- NDT testing of surfaces
- Sorting of material
- Frequency range up to 3.5 MHz
- Battery life approx. 8 hours
Frequency range 0.01 ... 16000 kHz
Probe voltage supply 0, 5, 1, 2, 4, 6 V
Signal phase shift 0 ... 360°
Sampling frequency 0 ... 10 kHz
Duration of signal fade-in
0 / 0.5 / 1 / 2 / 3 / 4 seconds
Alarm circular
horizontal line
circle sector
Display full-colour display (TFT)
Display size 4.3" (diagonal)
Display resolution
800 x 480 pixels
Amplification adjustment 0 ... 100 dB
Filter low pass filter (1 ... 4000 Hz)
high pass filter (1 ... 4000 Hz)
band filter
differential filter
average value filter
Average interval between measurement errors   4000 hours
Power supply 12 V battery
Battery capacity 4500 mAh
Continuous runtime per battery charge >8 hours
Operating temperature -20 ... +45 °C
Weight <0.9 kg
Dimensions 230 x 135 x 98 mm

1 x Condition Monitoring Flaw Detector PCE-USC 30
1 x Eddy current probe
1 x Calibration standard
1 x Software
1 x Probe cable
1 x Conductivity measuring probe
1 x Battery
1 x Battery charger
1 x Carrying case
1 x User manual