The Easycount-1-Schuko-G energy meter is an electricity meter for alternating voltages up to 230 V, enclosed in a splash-proof and impact-resistant housing. The cable ends of the Easycount-1-Schuko-G energy meter are equipped with male and female connectors.

- Calibrated counter
- Voltage input: 230 VAC
- Current rating: 16 A
- Frequency: 50 HZ

The PCE-THB 38 Pressure Gauge is ideal for detecting and digitally displaying humidity, temperature and barometric pressure. Temperature is measured by an RTD sensor and air humidity is measured by a highly repeatable, capacitive sensor. All products are test instruments, and the Pressure Gauge is sent out manufacturer calibrated. An ISO certification is available optionally.

- Temperature: 0 to 50°C
- Relative air humidity: 10 to 95% r.h.
- Barometric pressure: 10 to 1100 hPa (mbar)
- Dew point temperature: -25 to 49°C 

The PCE-THB 38 Relative Humidity Meter is ideal for detecting and digitally displaying humidity, temperature and barometric pressure. Temperature is measured by an RTD sensor and air humidity is measured by a highly repeatable, capacitive sensor. All products are test instruments, and the Relative Humidity Meter is sent out manufacturer calibrated. An ISO certification is available optionally.

Salt meter for EC and TDS (amount of salts and dissolved solid materials). Auto ranges up to 20,000 PPM.

- EC conductivity: 0...2000 µS/cm  /  0...20 mS/cm
- Salt content TDS: 0...2000 mg/l (ppm)  /  20,000 mg/l (PPM)
- Temperature: 0.0 ... 60 °C / 32 ... 140 °F
- Water resistant (IP 67)

The PCE-THB 38 Temperature Meter is ideal for detecting and digitally displaying humidity, temperature and barometric pressure. Temperature is measured by an RTD sensor and air humidity is measured by a highly repeatable, capacitive sensor. All products are test instruments, and the Temperature Meter is sent out manufacturer calibrated. An ISO certification is available optionally.

The thermo hygrometer is ideal for detecting and digitally displaying humidity, temperature and barometric pressure. Temperature is measured by an RTD sensor and air humidity is measured by a highly repeatable, capacitive sensor. All products are test instruments, and the thermo hygrometer is sent out manufacturer calibrated. An ISO certification is available optionally.

With the Water Analysis Meter PCE-CM 41, it is possible to measure conductivity value, the amount of all the solid material or dissolved salts  (TDS - Total Dissolved Solids) and the temperature. The Conductivity Tester is very easy to carry everywhere thanks to its small size.

- EC conductivity: 0...2000 µS/cm  /  0...20 mS/cm
- Salt content TDS: 0...2000 mg/l (ppm)  /  20000 mg/l (ppm)
- Temperature: 0.0 ... 60 °C / 32 ... 140 °F
- Water resistant (IP 67)