Humidity tester to measure absolute humidity of wood, building materials and paper, automatic temperature compensation, internal memory, interface and software.
It is used to couple up all the special sensors: head sensors for surfaces (to measure without causing damages in the material), surface sensors with short and extra-long pins ..
It is coupled with both pins to the universal probe holder. Humidity is measured with 4 x 1,5 mm length pins on a rounded metal surface divided into two parts. It is specially indicated to measure moisture content of cork, rubber, soft building materials and roof insulators.
It is coupled up with both pins to the universal probe holder. Humidity is measured with 4 x 17 mm length pins / it is specially indicated for gypsum, cement walls, pavements, lime-stones, materials for junctures, isolation materials, panelsIt is adjusted with both plugs to the universal probe holder.
It is adjusted with both plugs to the universal probe holder / humidity is measured by the two ends of the pins / it is specially indicated for great diameter woods, beams, timber planks as well as for diverse insulation materials and fibre or for light building foam materials as foams.
Sensor to be used in the universal probe support. The needle length is 250mm, needles are isolated in the first 175mm; They are ideal to be used for goods in sacks such as coffe, cocoa, wool, ... where a deep penetration in the material will be needed.
It is adjusted with both plugs to the universal probe holder / humidity is measured in the black measuring surface / this contact sensor works without causing any damages in the material / It is specially indicated to measure humidity on printed wall-papers, plastics, valuable woods and other building materials where it is important to measure without causing any damage.
Sensor to be used wih the universal probe support. It is ideal to detech absolute humidity in grains, seeds, granules, etc. Important: the connection cable KF-F must be included in the order.
All of our technical products have a 3 year
guarantee (within Europe), depending on the type of product. Outside of Europe
our products carry a one year guarantee.
Sponsoring
PCE Iberica S.L. is supported by the Astronomy and Geographic Society of Ciudad Real (SAGCR), on their expeditions to the antarctica with a donation of equipment appropriate to the working see our measuring equipment at work in the antarctic conditions that can be found there, where they obtain readings for radiation, gas, etc. under extreme polar conditions.
[More Info...]
Calibration
We are certified DIN ISO in almost all
manufactured measuring instruments,
especially laboratory
instruments.
Devices are purchased at the
stated prices and
prices will be
adjusted if neccesary. Together wth the device you
will receive a protocol of control.
Our DIN ISO calibrations and
verifications are
done by our associates.
Video of the Company
Design and manufacture of measuring equipment and scales. All available from one supplier.